← 70mai A810 4K Dash Cam Fix Guide

Fix the A810 Staying On After the Engine Is Switched Off

💻 Device: 70mai A810 4K Dash Cam 🗓 Added

Causes

  • The 12V socket stays live with the ignition off a large number of cars keep the cigarette lighter or accessory socket powered permanently, or for 30 to 60 minutes after locking. The A810 has no way to tell the engine stopped, so it records until the socket finally drops or until the car battery sags.
  • Parking mode is doing exactly what it was told with a UP03 or UP04 hardwire kit fitted, the camera switches to low power parking surveillance when ACC disappears. The screen goes dark but the status LED keeps blinking and clips keep appearing, which owners read as a camera that will not shut down.
  • The hardwire kit ACC wire is on a permanent fuse the kit has three wires and the yellow ACC lead has to land on a circuit that goes dead with the key. Tapped onto a battery fuse alongside the red lead, the camera never sees the ignition cycle, so parking mode neither starts nor ends and it records continuously.
  • A generic hardwire kit or a USB adapter is back feeding the camera cheap kits and USB sockets wired to a permanent live keep the port energised. The A810's 500mAh internal battery then never fully isolates the camera, so it appears to run on its own after the ignition is cut.
  • Parking mode is set to continuous surveillance the parking menu can be left on all night recording instead of time lapse or collision triggered. The camera is behaving correctly, but it draws far more than the intended parking profile and will flatten a healthy battery overnight.
  • The camera is stuck after a failed shutdown a firmware fault or a hot shutdown can leave the A810 hung with the LED lit and the screen frozen. In that state it stays powered from the internal battery or the port and ignores the ignition state entirely.

How to Fix

  1. Measure the socket with the key out. Leave the ignition off, lock the car, wait a minute, and test the socket with a 12V tester or multimeter. Anything near 12V means the socket is permanently live and the camera is correctly recording on live power.
  2. Decide whether you want parking surveillance. If you do not, unplug the camera when you park, or move the feed to an ignition switched circuit. If you do, fit the 70mai UP03 or UP04 hardwire kit rather than a generic one.
  3. Verify all three hardwire wires. Red to a permanent battery fuse, yellow to an ACC fuse that reads 0V with the key out, black to a clean ground point. Confirm the yellow lead with the meter at the fuse tap, not just by eye, because fuse box labels are frequently wrong.
  4. Set the low voltage cut-off. In the parking mode settings pick a cut-off that protects the battery, and confirm the camera actually stops. A camera that keeps recording until the car will not start was set too low or is on a kit with no cut-off.
  5. Change the parking profile. Set time lapse at the lowest frame rate for all night parking, and use collision or motion triggering where the car sits in a busy area. Continuous parking recording is the setting that drains batteries fastest.
  6. Watch the status after ignition off. With a correct install the screen goes dark within seconds, the LED blinks slowly in parking mode, and no new full length clip appears in the app. If a normal clip is still being written after 10 minutes, power is still present.
  7. Reboot and update if it is hung. Hold the power button until the camera restarts, or unplug it for 30 seconds, then install pending firmware through the app. A camera that only misbehaves after a hot day usually needs the update and a cool restart.
  8. Test on a bench supply if the behaviour continues. Run the A810 from a 12V adapter indoors with no hardwire kit. If it still refuses to power down, the USB-C port or the internal battery circuit is faulty and the unit needs warranty service.